Gravity Digital 5A Relay Module
The DFRobot relay module is a standard relay that is controlled by a microcontroller to switch larger consumers such as pumps, solenoid valves, lamps, motors or lamps. The relay has a status LED to visually display its ON or OFF switching state. The relay is controlled via the digital IO port. The relay module can be operated with 3.3V or 5V microcontrollers. You can also use it for the Raspberry Pi or ESP.
For safety reasons, you should only operate the relays up to 30V, since the back of the PCB is not isolated and can be dangerous if carelessly handled with 230V.
Documentation:
- DFRobot Wiki
Technical Details:
- Number of channels: 1
- Rated Pass-through Current: 10A (NO) 5A (NC)
- Maximum switching voltage: 150VAC 24VDC
- Interface: Digital
- Control signal: TTL-Level
- Switching Power (Res. Load): 10A 250VAC / 24VDC
- Max. Switching voltage 250VAC / 30VDC
- Dimension: 38 x 33 x 20mm
- Weight: 25g
Scope of Delivery:
- 1x Gravity MOSFET driver module 10A
- 1x Gravity 3pin digital sensor cable PH2.0 to XH2.54
